- 3 -
interference. If it lights periodically in a certain location, it indicates that there exist
pollutants in the corresponding location on the conveyer belt. Interference should be
eliminated. The conveyer belt should be cleaned.
c)
The level: there sets up a display of the level of induction for the instrument. The more
the light pillars are
，
the higher the level of the induction of the instrument is.
d)
The monitor: the dynamic induction of the instrument indicates that the more of the light
pillars are, the higher intensity the instrument affected from ferromagnetic materials.
When it is in operation, it reflects the size of the mass of the ferromagnetic materials and
the relevant distance of the detective sensor. If it is not working while the light pillars
lights repeatedly, it is advised that we examine whether there exists outward interference,
such as high-tension wires, power transformers, electro motors, and mechanical facilities,
or whether there is wobble and pollution on the conveyer belts.
e)
The start: the button is start or pause.
Auto-Conveyance Magnetic Induction Metal Detector LX-630A
1.
Operation Instruction:
a)
To connect with the alternating current power supply that has a earth wire with
appropriate voltage required by the instrument;
b)
To press “POWER” (the red button on the electric board) and the “START” (on the board
of operation), the conveyer belt will start operation. The detection can then begin. The
conveyer belt will stop if the “START” is pressed again.
c)
There installed a display of the level of detection induction and a display of the detection
location on the operation control panel where there are an automatic warning device and
a counter. The instrument will alarm automatically if it detects draw points or iron
containing metals. The indicator lamp will display the location of the detection and the
conveyer belt will stop operation. Products that are not up to the standard will be
returned to the operators while those that are up to the standard will pass the detection
and count. Those that are not up to the standard will not be counted.
2.
Points for Attention:
a)
Please test-detect the sample draw points, iron fragments, or the attached parts for
detection by the instrument. Make sure that the instrument works normally only if it
alarms and the conveyer belt stops in the process of trial detection.
b)
The materials that could be detected through the instrument are ironwork and
iron-containing materials. Non-ferromagnetic materials such as pure aluminum, copper,
etc are unable to be detected.
c)
The instrument is reactive to movable metal materials. Operators are required not to
carry any of them in the process of operation.
How to Use
Points for Attention
