RehabMedic Magneto Pro 100, User Manual

Page: 58 / 64

56 Rev.02.17 del 27.10.2017
Is it possible to place the solenoids over clothing?
Of course, the positioning above the garment does not affect the treatment in depth.
Is it possible to place the solenoids over a plaster cast?
Of course, the plaster cast does not affect the emission of magnetic flux.
What to do if you feel too much heat?
Place the solenoid above the garment and for the first sessions lower the magnetic flux of a few
Gauss.
Should the strap be cleaned after use?
If it is well maintained it is not necessary to clean it.
Should I feel a vibration and/or heat during the treatment?
It is possible to feel a slight sensation of heat. The magnet does not emit any kind of vibration so
it is quite normal not to feel anything during the treatment.
How to check if it emits?
Select a program, set the maximum power, approaching a staple in the middle of one of the two
coils, you should feel a slight vibration.
PROGRAMS
Is it possible to enter a new program?
Of course. Selecting “Programming” you can store the parameters prescribed by your doctor and
save the new program.
Is it possible to set more than 5 hours?
Of course. The device allows to be set until 9 hours and 59 minutes.
Is it possible to change the parameters in the preset programs?
Certainly. The device has the possibility to change the time and gauss. For further information,
please consult the manual in the section “Instructions for use”.
FAQ
SOLENOIDS
Is it possible to connect two different solenoids (diffusers)?
No. The device communicates with two solenoids (diffusers) of the same model.
How do I place the solenoids on the various joints?
For a deep treatment you have to place the two poles of the solenoid in a parallel way to the
joint to be treated; for the treatment of large areas (paravertebral, femur) roll out the band on the
treatment area.
Check the manual for each program and its positioning of the solenoids in the section “Main areas
of the body to be treated.”
In which direction do I place the solenoids?
To act in depth the two poles must be opposed (SOUTH/NORTH or NORTH/SOUTH). The NORTH
pole is identified through the logo screen printed on the band. For further information see the
section in the manual “example of connection of the diffusers“