22
z
seize the magnetic tape by its edge (see Figure 5, pos . 3) and pull it out for a desired length,
relative to the blade edge (Figure 5, pos . 2) . Case of the cutter can be used for measuring
the approximate length of the magnetic tape strip (Figure 5, pos . 4): a full loop of a tape
around the case is equal to the working magnetic tape strip length – 250 mm;
z
lower the cutter lever (Figure 5, pos . 1) and slightly press it down to fix the tape as
shown in Figure 5b;
z
tear the tape along the blade edge (Figure 5, pos . 2) . It is better to “twist” the tape
but not “tear” it (Figure 5b) . When tearing the MT avoid forming fins on strips’ edges;
z
put the obtained magnetic tape strip by its concave edge under the blade of the cutter
and tear another edge similarly;
z
stack the cut MT strips into the cartridge for magnetic tapes storage (Figure 1b, pos . 11)
into the compartment marked with green marker (demagnetized MT) .
Figure 5
1 — lever;
2 — blade;
3 — magnetic tape;
4 — case;
5 — bunker with magnetic tape reserve;
6 — site for magnetic tape pulling out .
6
5
4
1
2
3
а)
magnetic tape extraction from the bunker of the cutter
b)
cutting magnetic tapes by the cutter
Summary of Contents for 7505M
Page 2: ......
