17
User’s Guide
Document Reader Regula 70X4M.XXX
3) make sure the PC hardware and software configuration meets
the requirements specified in the Introduction of this User Guide;
4) install missing software components, if necessary (see Appendix B);
5) Download
Regula Document Reader SDK.exe
from
the Internet resource (see Appendix D), run the installation file,
and
following the instructions of Installation Wizard install the device
software (the device camera driver, Document reader SDK,
RFID reader driver, and RFID SDK).
2.2.3.2 Preparing the Device for use
1. Perform the operations specified in paragraphs 2.2.2 and 2.2.3.1.
2. Connect the device to the PC using the USB cable. Connect
two (2) sockets of A type of the cable from the delivery set to the PC,
then connect the socket of B type of the same cable to the device.
A message on detecting new devices on the USB bus and the Hardware
Installation Wizard window will appear on the PC monitor; the system
will start installing drivers automatically.
3. Wait until the Installation Wizard is finished and make sure
indicator
(5)
comes on Yellow or Orange, which indicates that
the installation of the device driver is successfully installed to the PC
(Appendix B).
2.2.3.3 Testing the device operation
1. Prepare the PC and the device for operation under the instructions
specified in paragraphs 2.2.3.1 and 2.2.3.2.
2. Start
Readerdemo.exe
application using the shortcut on
the desktop;
All operations with the Test Application must be performed under
the instructions specified in the
“Test Application (Readerdemo.exe)”
documentation (
see
Document Reader SDK\Doc\Test Application (en).pdf
in the SDK installation folder – by default C:\Program Files\Regula);
3. Initialize the device and make sure that in 10-15 seconds,
indicator
(5)
colors will change to Green, indicating that the initialization
is successfully completed.
CAUTION:
During device initialization
Readerdemo.exe
checks
conformit y of the device firmware version and
Document
Reader
SDK
version . If necessary Readerdemo.exe offers
to update device firmware.
4. Scan the document. Place the document on object-plate
(2)
fig. 1
up to the stop to the left and back panels.
The device will switch
to the
reading mode
for 1-3 seconds, and the document image will be
displayed in the application window.