15
User’s Guide
Document Reader Regula 70X4M.XXX
After the device is connected to the PC, indicator
(5)
fig. 1 will
come on Yellow or Orange (provided that the device driver is already
installed; see paragraphs 2.2.3.1 and 2.2.3.2).
After the device and the SDK software is initialized
(see paragraph 2.2.3.3), the device will switch to the standby
mode
,
and indicator
(5)
fig. 1 will come on Green. When putting the examined
document (up to the stop to the left and back panels) on object-
plate
(2)
fig. 1, the document edge overlaps photoelectric sensor.
A sensor signal goes off, and the device starts
scanning
that is shown
by indicator
(5)
fig. 1 with Orange or Red. At this stage the device will
capture the document image under specified lighting conditions, read
the RFID tags data and transfer the data to the PC. After that, the data
is processed by the software components DR SDK and depends on
the functions specified by the User’s application (Programmer’s Manual
for DR SDK, paragraph 6). When the document processing finished,
the device switches to the standby mode, and indicator
(5)
fig. 1
changes to Red or Green depending on the reading/scanning results.
The scanning mode can be also initialized by the user application
command.
Data reading-out from the smart-cards is performed to
the corresponding application after the smart-card is inserted up to
the stop into slot
(9)
of the device (fig. 2).
Marking and Sealing
The device marking meets IEC 62368 and contains:
CE marking;
manufacturer’s name and/or trade mark;
manufacturer’s model identification;
manufacturer name and address;
the serial number of the device according to the
manufacturer’s numbering system;
the symbol for nature of supply;
rated power supply voltage, V;
rated current consumption, A;
“Made in Latvia” inscription;
FCC ID number;
IC ID number;
The WEEE symbol.
1.5.2 The seal is located on the bottom of the device.
Packaging
The package ensures device safety during its transportation and
storage.
1.5
1.6