V
09/2011
Temperature Control Unit 300L(D)/350L(D)
General Safety Information
•
3
an independent process monitor that reliably shuts down the plant must
be used.
Information for Operators and Personnel
The operator and all persons who are tasked with working on the tem-
perature control unit must obey the fundamental regulations regarding
work safety and accident prevention. The operator must ensure that only
persons who have read and understood these operating instructions, in
particular the chapter on safety, may work on the temperature control
unit.
Any working methods that have a negative effect on the technical safety
of the temperature control unit must not be used. The operator must en-
sure that the temperature control unit is operated only in flawless condi-
tion. If necessary, the company using the equipment must obligate the
operating personnel to wear protective clothing.
For all tasks relating to set-up, start-up, operating, modification of operat-
ing conditions and operational methods, maintenance, inspection and re-
pair, any shut-down procedures stated to be necessary in the operating
instructions must be followed.
Changing the Parameter Settings
The parameterisation of the control system may only be carried out by
personnel trained by Regloplas. In particular, no parameters in the device
configuration may be changed without consulting Regloplas.
The relevant accident prevention regulations and the generally accepted
principles of safety engineering, occupational medicine and structural en-
gineering must be observed. The national safety regulations must also be
obeyed.
Residual Risks
Any unauthorised modifications and changes to the temperature control
unit as well as unauthorised changes to the parameterisation of the con-
trol system are prohibited for reasons of safety.
If the temperature control unit is damaged, it must not remain in use; the
defective part must be replaced or repaired immediately. Only original
Regloplas replacement parts may be used. Damage due to use of third-
party parts voids any and all warranty claims.
DANGER
The temperature control unit must be disconnected from the electrical power
supply before it is opened (unplug the mains plug and, if fitted, press the main
switch on the temperature control unit). Danger of electric shock!
Any leaks in the temperature control circuit (device, connecting lines,
consumers, etc.) must be repaired immediately.
In the case of temperature control units that use oil as the heat transfer
medium, please remember that oil is flammable under certain conditions.
For this reason, the temperature control unit must not be located close to
heat sources. The thermal insulation in the device must always be kept
clean. Insulation that is soaked with thermal oil poses an increased risk of
fire.
