V
09/2011
2
•
General Safety Information
Temperature Control Unit 300L(D)/350L(D)
Range of Application
This general safety information is generally valid for all temperature con-
trollers and control systems from Regloplas.
Intended Use
The Regloplas temperature control unit is built according to the current
state of the art and the generally accepted principles of safety engineer-
ing. The temperature control unit is intended solely for the normal use for
heating and/or cooling of injection moulds and die casting dies, extruders,
calenders, mixers and other consumers in areas where there is no risk of
explosion.
Any use beyond this shall be deemed to constitute improper use. The
manufacturer is not responsible for damage resulting from improper use;
the user is solely responsible for such risks. The temperature control unit
may not be used under other operating conditions and/or with other me-
dia, in deviation from our specifications, without the prior consent of Re-
gloplas AG.
The intended use also entails compliance with the operating, servicing
and maintenance conditions stipulated by the manufacturer. The tem-
perature control unit may only be operated, serviced and maintained by
personnel who are familiar with these tasks and have been instructed as
to the risks.
Safety Information
General Information
The Regloplas temperature control unit is safe to operate but can cause
danger if it is used incorrectly or for a purpose other than its intended
use. It should be noted that any such incorrect use or non-compliance
with the intended use can cause risks to the life and limb of the user or
third parties, adverse effects on the equipment and other material assets
belonging to the user, and risks to the efficient operation of the equip-
ment.
Start-up (i.e., commencement of intended use) is prohibited until it has
been determined that the temperature control unit has been set up and
wired in accordance with the Machinery Directive (2006/42/EC).
EN 60204-1 (Safety of Machinery) must also be observed.
These operating instructions must be read carefully before switching on
and operating the temperature control unit. The information regarding the
intended use and foreseeable misuse must be observed. Local safety re-
gulations must also be obeyed.
If the temperature control unit is used in combination with products made
by other manufacturers, the notices and safety regulations of these ma-
nufacturers must also be obeyed.
Process Monitoring
In plants in which a malfunction of the temperature control system leads
to endangerment of the operating personnel or destruction of the plant,
