E33 FPI Direct Vent Gas Insert
11
INSTALLATION
GAS CONNECTION
1)
If the appliance is to be installed into an existing
chimney system, thoroughly clean the masonry
or factory built fi replace.
2)
The appliance is provided with an opening on
the left hand side of the control compartment.
A 3/8" NPT gas supply pipe must be brought
near this inlet hole.
3)
Locate the center point where the vent will pass
through the chimney above the appliance. Move
the appliance into the exact location where it is
to be installed. Ensure that the Insert is level.
5)
Install
fl ashing.
6)
Insert both liners into chimney, passing through
the damper opening.
7)
Install termination cap.
8)
Connect the
marked end
of the liner to the
exhaust collar of the vent connector plate
marked with an "E", seal connection with high
temperature silicone. Secure with gear clamp.
9)
Connect the 2nd liner to the intake collar, seal
connection with high temperature silicone.
Secure with gear clamp.
NOTE:
1)
Final gas connection should be made after
unit is in place to avoid damage to line when
pushing the unit into position.
2)
Mill-pac may be used instead of high tempture
silicone and screws may be used instead of
gear clamps at connections of liner to inlet and
vent collars.
10)
Align vent connector plate with guides on unit.
11)
Slide unit into masonry opening, while ensuring
that the slot at the rear of the connector plate
mates up with the hold down plate on the unit.
12)
Secure with Screw.
THE APPLIANCE MUST NOT BE
CONNECTED TO A CHIMNEY FLUE
SERVING A SEPARATE SOLID FUEL
BURNING APPLIANCE.
GAS CONNECTION
WARNING:
Only persons licensed to work
with gas piping may make the
necessary gas connections to
this appliance.
