12
E33 FPI Direct Vent Gas Insert
INSTALLATION
OPTIONAL
BRICK PANEL
Optional Brick Panel Set:
Part # Description
Qty
Top (brick) panel
1
Back (brick) panel
1
Left (brick) panel
1
Right
(brick)panel
1
340-043 Top
bracket
1
340-094 Bottom
clips
2
511-031 Brick clips
2
GAS PIPE
PRESSURE TESTING
The appliance must be isolated from the gas supply
piping system by closing its individual manual shut-
off valve during any pressure testing of the gas
supply piping system at test pressures equal to or
less than 1/2 psig. (3.45 kPa). Disconnect piping
from valve at pressures over 1/2 psig.
The manifold pressure is controlled by a regulator
built into the gas control, and should be checked
at the pressure test point.
NOTE: To properly check gas pressure, both
inlet and manifold pressures should be
checked using the valve pressure ports
on the valve.
1)
Make sure the valve is in the "OFF" position.
2)
Loosen the "IN" and/or "OUT" pressure tap(s),
turning counterclockwise with a 1/8" wide fl at
screwdriver.
3)
Attach manometer to "IN" and/or "OUT"
pressure tap(s) using a 5/16" ID hose.
4)
Light the pilot and turn the valve to "ON"
position.
5)
The pressure check should be carried out with
the unit burning and the setting should be within
the limits specifi ed on the safety label.
6)
When
fi nished reading manometer, turn off the
gas valve, disconnect the hose and tighten the
screw (clockwise) with a 1/8" fl at screwdriver.
Note: Screw should be snug, but do not
over tighten.
SIT VALVE DESCRIPTION
1)
Gas on/off knob
2)
Manual high/low adjustment
3)
Pilot
Adjustment
4)
Thermocouple Connection -
option
5)
Manifold (Outlet) Pressure Tap
6)
Inlet
Pressure
Tap
1
2
3
4
5
6
IN
OUT
7)
Pilot
Outlet
8)
Main Gas Outlet
9)
Alternative TC Connection Point
