Regency G51 UltraGlow
19
OPERATING INSTRUCTIONS
COPY OF LIGHTING PLATE INSTRUCTIONS
ANY SERVICING OR REPAIRS
SHOULD BE CARRIED OUT ONLY BY AN
AUTHORISED PERSON.
A) This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these in-
structions exactly.
B) BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
-
Do not try to light any appliance
-
Do not touch any electric switch, do not use any
phone in your building
-
Immediately call your gas supplier from a neigh-
bours phone. Follow the gas suppliers instruc-
tions.
-
If you cannot reach your gas supplier, call the fire
department.
C) Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, dont try to repair it, call a
qualified Service technician. Force or attempted
repair may result in a fire or explosion.
D) Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
This appliance needs fresh air for safe operation and
must be installed so there are provisions for ad-
equate combustion and ventilation air.
CAUTION: Hot while in operation. Do not touch. Severe
Burns may result. Due to high surface temperatures
keep children, clothing and furniture, gasoline and
other liquids having fammable vapors away. Keep
burner and control compartment clean. See installa-
tion and operating instructions accompanying appli-
ance.
FOR YOUR SAFETY READ
BEFORE LIGHTING
This appliance must be installed in accordance with local
codes, if any; if not, follow current CAN1-B149/ANSI
Z223.1 Australia: AS5601-2004/New Zealand: NZS 5261.
WARNING: If you do not follow these instructions exactly,
a fire or explosion may result causing property damage,
personal injury or loss of life. Improper installation,
adjustment, alteration, service or maintenance can cause
injury or property damage. Refer to the owners informa-
tion manual provided with this appliance. For assistance
or additional information consult a qualified installer,
service agency or gas supplier.
LIGHTING INSTRUCTIONS
1) Open screen door, if used.
2)
Open valve cover.
3)
Turn ON the shut off valve.
4)
Fully press the ignition button and ignite the
pilot burner by continously depressing the
peizo ignitor. Once the pilot has lit, continue
holding in the ignition button for approximately
10 seconds to ensure the pilot stays on. If it
goes out, wait 1 minute and repeat the ignition
operations.
STOP! Read the safety information above on this label.
Normal Operation:
Press and release the ignition button again to ignite the burner.
Flame Selection:
Press the flame button for the flame adjustment. For minumum
flame, depress the button. For maximum flame, release the
button.
Pilot Position:
Press and release the ignition button to turn off the burner
flame. The indicator should show the ignition symbol.
5)
Close valve cover.
6) Close screen door, if used.
TO TURN OFF GAS APPLIANCE
918-249
DO NOT REMOVE THIS INSTRUCTION PLATE
You may shut off the pilot during prolonged
non use periods to conserve fuel.
Turn OFF the shut off valve to shut down the pilot and
burner.
Always install screen door during operation to reduce
risk of injury.
