Regency
®
PG36D Gas Log Fireplace
24
Diagram 3
Use the hook to pull the spring out until you
can put the hook into the slot on the bottom
door bracket. Repeat for 2nd spring. See
diagram 3.
Diagram 2
The standard fl ush door
comes with a black
frame. To install the frame, simply hook the top
door fl ange onto the top of the unit and swing
the door towards the unit, diagram 1.
Be careful that the glass gasket does not roll up;
there must be a gap between the gasket and
the door lip to ensure that the door sits securely
on the unit. Diagram 2.
Diagram 1
To remove the fl ush door, reverse the above
steps.
11) Test fi re to ensure proper light off (make
sure fl ame fl ows smoothly from one end of
burner to the other). If there is any fl ame
hesitation, check that area for any blockage
of the burner ports.
12) Install fl ush glass and bay glass (if used)
as per instructions in this manual.
Do not block the burner holes in this
area adjacent to the Log 02-54
02-51
02-54
02-50
02-55
02-75
02-53
02-51
02-54
02-
MANUAL CONTROL
SWITCH INSTALLATION
1)
Open bottom louver.
2)
Mount clip on louver - adjust accordingly
(by sliding) with mounting hole from manual
control box.
3)
Secure manual control box (located in the
base of the fi rebox) to the louver using 3
screws.
4)
Tuck wires away and close bottom louver.
STANDARD FLUSH
DOOR
INSTALLATION
