Access Code into Memory
In most cases, this feature is not
used. It is usually only required
when the telephone is installed
outside of a residential application
where you may have to dial a
number(s), such as "9", to get an
outside line. Whatever number(s) is programmed as an Access
Code will automatically be dialed, followed by a 3 second
pause, prior to any number dialed from Speed Dial, or from the
Call Back Feature.
To set up the access code:
1
Press the
DIRECTORY / STORE
key until the display screen reads
ENTER ACCESS CODE
.
2
Enter the desired number, such as 9.
Note:
There is no need to enter
PAUSE
. The Dial Call Back
operation automatically inserts a 3 second pause after the
access code number is dialed.
To delete the access code:
1
Press the
DIRECTORY / STORE
key until the display screen reads
ENTER ACCESS CODE
.
2
Press the
DELETE
key.
3
Press the
DIRECTORY / STORE
key again and the screen will go
back to its normal position after a 15 second delay.
User’s Guide
Programming The Telephone
20
Regency™ Series 400 Single Line Caller ID Telephone
User’s Guide
Programming The Telephone
Regency™ Series 400 Single Line Caller ID Telephone
15
Speed Dial
continued
Manual entry
for memory storing
1
Confirm the display is in the idle mode as
shown in Figure 1.
2
Press the
DIRECTORY / STORE
key until the
LCD display is similar to Figure 2.
3
Press the
UP / DOWN
key to change the
memory location to the desired memory
location. (MEM 1, MEM2, … MEM10) (See
Figure 2 then 3.)
4
Enter the name by pressing the alphabetic
characters repeatedly on the keypad.
(see keypad guide on next page)
5
Use delete key to delete an incorrect
entry.
6
When the name is complete, press the
DIRECTORY STORE
key once to store the
information.
7
The LCD will request
NUMBER
(Figure 4.)
8
Enter the number using the dialing
keypad. Press the DIRECTORY STORE key.
9
Press the
DIRECTORY / STORE
key twice to
bypass the store
AREA CODE
and
ACCESS
CODE
. These two areas are not part of the speed dial programming and any
changes could affect the proper operation of other features. See pages
13-15 for further information about
AREA CODE AND ACCESS CODE
.
To program additional numbers, repeat steps
2
thru
9
.
Manual entry from keypad (guide).
Figure 1
Figure 4
Figure 3
Figure 2
Summary of Contents for 400 Series
