8
|
F5200 Regency Freestanding Woodstove
|
8
installation
Side View
Rear Heat Deflector
Screws
Diagram 2
Diagram 3
STOVE ASSEMBLY
PRIOR TO
INSTALLATION
The F5200 unit requires the pedestal attached
to the base. The F5200 stove requires either
the Airmate or Rear Heat Deflector on top of
the stove. Clearances to combustible materials
vary depending on whether the airmate or rear
heat deflector is installed, so be sure to check
the Minimum Clearances, Installation section.
Airmate Assembly for F5200
1.
The Airmate sits on top of the stove with
the slots in the sides fitting over the curved
deflector on the rear stove top. See Diagram
1. Recycle the Rear Heat Deflector that is
supplied with the unit, it is not required if the
airmate is installed.
2.
Center the Airmate and push it forward to the
front of the stove. The back of the airmate
should be level with the back and sides of
the rear heat shield. See Diagrams 2 & 3.
Rear Heat Deflector
Assembly for F5200
The rear heat deflector is supplied with the stove
and must be installed unless the optional airmate
has been selected. It stops the heat radiated from
the flue collar from overheating the rear wall. The
rear heat deflector is installed on top of the rear
heat shield, as shown in Diagram 4.
Side Shield Adjustment
The left and right side shields are lowered for ship-
ping and handling. It allows for a handhold on the
top of the stove. Before placing in the Step Stove
in its final position, the side shields must be raised.
Loosen the screws on the rear on the stove (3 per
side), slide the side panel up as far as possible and
then secure by tightening the screws.
1.
P u s h
t h e
Regency logo
into the two
holes in the
front bottom left
corner of the
pedestal cover
plate.
Note: Any paint touch up should be done prior
to placing logo on pedestal.
2.
If not using ash drawer, then cover plate must be
installed.
Airmate
Rear Heat
Shield
Side
Shield
Stove
Diagram 1
Diagram 4
Diagram 5
Diagram 6
Logo Installation
