Regal 35 Sport Coupe, Owner'S Manual

Page: 50 / 214

1
Chapter 4
Engines & Controls
ENGINES
MANUFACTURER’S MANUALS
It is important that you read the manufacturer’s engine
manual carefully and become completely familiar with the
operation as well as necessary maintenance on the engine
and propulsion systems. Your Regal dealer has been factory
trained on all Regal boat systems. Consult your Regal dealer
for further information regarding technical issues and parts.
Use only approved marine replacement parts.
ENGINE MOUNTS
The engines are placed in the boat on a set of metal or
wooden platforms called mounts. These rubber isolation
mounts keep the engine from moving laterally and athwart
ships (right angles to the center line). The mounts help
reduce the vibration caused by the engine and drive.
Periodically, the mount hardware should be checked for
tightness.
ENGINE ALIGNMENT
Mercruiser stern drives use a rubber splined hub to which
the stern drive shaft is attached. There is an alignment
specification between the engine and outdrive that needs
to checked periodically. A special alignment shaft is greased
at the tip and inserted through the gimbal housing. The
alignment angle can be determined by the spline image left
on the tool. The engine mounts are then adjusted to permit
a similar spline image 360 degrees around the greased
alignment tool. This specification should be checked after
each 50 hours of operation or if the vessel has run aground
or hit a submerged object. Alignment should be checked
by a Regal dealer or marine professional since a special tool
and procedure is required.
ENGINE REMOVAL
In the event the engine requires major service and needs to
be removed, consult your Regal dealer. The dealer possesses
the knowledge and factory training necessary to accomplish
such a job. Do not undertake this type of repair yourself.
AVOID SERIOUS INJURY OR DEATH!
5($'$//0$18)$&785(5·6(1*,1(
$1'35238/6,212:1(5·60$18$/6
%()25(23(5$7,1*<2859(66(/