-4-
Water Bottle
Boiling Chamber
Distiller Chassis
PREPARE YOUR DISTILLER
Before using your distiller for the first time, please follow the steps below.
CLEAN THE WATER BOTTLE
First, make sure the dispensing valve is installed and tightened onto the water
bottle. Then fill the water bottle about
3
⁄
4
full with water. Add one or two
drops of dish detergent to the water.
Do not install the carbon filter at this
time.
Seal the bottle’s top opening with the cap supplied. Shake the bottle
vigorously and then drain. Rinse the bottle thoroughly to remove all of the
detergent.
NOTE:
Do not allow the soap/water mixture to remain in the water bottle for
long periods of time. Do not use the water bottle to store liquids other than
distilled water . Liquids other than distilled water may transfer a taste or odor
to the water bottle.
TO SANITIZE WATER BOTTLE
Add 4
3
⁄
4
ounces (150 ml) of 3% hydrogen peroxide solution (H
2
O
2
) to the
water bottle. Fill the bottle with hot (160˚F/71˚C) distilled or tap water.
Do
not install the carbon filter at this time.
Cap the water bottle and shake the
vigorously. Let stand for twenty minutes then drain thoroughly. Rinse with
room temperature distilled or tap water, then drain. Water bottle may be used
immediately or allowed to air dry.
PREPARE THE CARBON FILTER
To prepare the carbon filter, place it in boiling water for five minutes. Drain
excess water from filter . Place the filter into the water bottle. The same cleaning
process should be used whenever a new replacement filter is installed. The
{ {
{
Dispensing
Valve
Cap
Boiling
Chamber
Cap
Baffle
Securing
Nut
Cord
Cooling
Vents
Filter
Flat Gasket
O-Ring
