-9-
Problem
Possible Cause
Solution
Distiller does not
Distiller is not plugged in.
Plug the distiller into a rated
.t
e
lt
u
o
.
e
t
a
r
e
p
o
Outlet is defective or fuse
Check fuses or circuit
or circuit breaker has
breakers or call a licensed.
tripped.
electrician.
Electrical power has been
Press start button to restart.
interrupted.
See #9 on page 6.
Steam appears near
The baffle is missing or
Properly install the baffle.
the top of the boiling improperly installed.
See #6 on page 5.
chamber.
Boiling chamber cap is
Securely install the boiling
missing or loose.
chamber cap.
Water leaking from
The cap is on the water
Remove the cap from the
top of distiller.
bottle.
water bottle during
distillation cycle.
The distiller shuts
Loose baffle, missing
The screwed fitting can
off before the cycle
baffle or baffle is not
become loose during cycles.
is complete.
secured properly in the
Assure that this fitting is
spout of the boiling
tightened before each use.
chamber.
The baffle must be installed
with the flat side down (this
means that the hole is down)
and the narrow end inser ted
into the spout of the boiling
chamber. See page 6.
The distiller is not in a well
Distiller must be operated in
ventilated area.
a well ventilated area for
proper heat dissipation.
Machine is equipped with
resetable fuse. If the machine
shuts off due to poor
ventilation, allow unit to cool
and reset. Start the machine
by reinserting the boiling
chamber and pushing the
start button. See page 6.
There is excess scale
Clean the boiling chamber.
build-up in the boiling
See page 7.
chamber.
The distilled water
The carbon filter is
Replace the carbon filter.
has an unusual taste. contaminated.
See page 4.
The water bottle is in
Clean the water bottle.
need of cleaning.
See page 4.
The boiling chamber
Do not overfill the boiling
has been overfilled.
chamber. Fill to bottom of
the four tabs at the base of
the boiling chamber’s fill
opening. See #4 on page 5.
TROUBLESHOOTING GUIDE
