Reese Aitchison Seedmatic 40 D Series, Manual

Page: 60 / 64

59
Introduction
This is a standard designed control by Hollin Applications for the general
use in agriculture.
Using a small magnetic reed relay sensor mounted close to the wheel or
propshaft with the magnet fixed to the rotating mechanism, the unit
counts the number of turns and the rotational speed of the ground wheel.
There is a second magnetic sensor or switch input which can be used to
disable the area counts at headlands etc. This can be paralleled up to a
pause switch if required.
The unit stores all relevant information at switch off.
Two panel buttons allow for all adjustments of the functions on the large
display.
Technical
Power supply - DC 10 to 30 Volts low current.
Fused - not applicable
Dimensions -
6” * 4” * 21/2”
Display - 4 character, some alphanumeric
- Optional backlight.
Magnetic Reed Sensor - M12 nylon, 40mm length, 2 mounting
nuts.
- Protection fitted to the wheel sensor.
- Working distance to magnet 10 to 25mm
Circuit board - Standard Monitor unit – ST6265
Processor 8MHz
-
Memory retention of Count and options
Installation
Mount the control box within the cab so that the display can be easily seen.
Position using a suitable bracket and the side mount M6 bolt fixings.