HIDEAWAY
ACTIVE SENSOR-FLUSH URINAL
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
HIDEAWAY
ACTIVE SENSOR-FLUSH URINAL
4.0
Urinal Installation Instructions:
1. Cut out paper template supplied, place in position flat on wall aligning centre of cut out holes with inlet and
outlet.
2. Mark hole centres through template onto wall to provide wall l
ocations for two ‘L’ shaped brackets (Fig. 5).
3.
Fit ‘L’ shape mounting brackets to wall with fixings supplied (Fig. 6)
.
4. Before fitting waste trap, cut 50mm PVC DW V flush with finished wall (Fig. 7).
5. Fit kee-seal to waste trap and lubricate before gently pushing into 50mm PVC DW V pipe so trap finishes flush
with face of wall. Fix waste trap to wall with single screw (Fig. 8).
6. Ensure sensor cable is installed through finished face of wall and connected to trap before installing urinal.
7. Lubricate and fit rubber inlet seal to trap. Carefully lift urinal into installed position, ensuring it is fitted with:
Inlet pipe fully inserted into urinal rubber inlet seal
Outlet fully inserted into waste trap inlet seal
Urinal mounting screws are fitted using plastic sleeves provided and tightened into L shape brackets (Fig. 9).
IMPORTANT: DO NOT OVER TIGHTEN SCREWS AS THIS MAY CRACK URINAL SIDE WALL
Fig. 5
Fig. 6
Fig. 7
page 4 of 16
