5
Any revisions must first be approved by the product designer. Version: 201808
Revision By: JST
11.
FASTENING GLASS
Secure the glass panels into the receiver
channels by tightening hex key screws
firmly with hex key supplied. DO NOT
OVERTIGHTEN.
12.
PROTECTION OF GLASS EDGE
Apply 1mm plastic packer to the edge of
glass with the masking tape as shown.
Position one next to each hinge cut out.
This will
ensure
correct
door
clearance
and
prevent
glass
damage.
13.
CLEARANCE UNDER DOOR
Place 6mm Spacers over the door infill
before the installation of the glass door.
14.
HINGE INSTALLATION
Atlantis glass is now coated with
CristalCote glass protection at the factory.
This coating may cause the hinge to slip
after installation. Atlantis recommends
cleaning around the hinge cut out prior to
fitting hinges. Clean both sides of the
glass 15mm around the edge of the cut
out with Fuelite (fuellite is available from
petrol stations). Alternatively, the area
can be lightly sanded with 300grit
sandpaper.
ADJUSTABLE HINGES
Atlantis showers are now supplied with
adjustable hinges
COVER PLATE REMOVAL
Remove the cover
plate by loosening the
small grub screws on
the edge of the hinge
cover using a 1.5mm
hex key. Loosen the
bolts with 4mm hex
key. Fit the hinges,
the removable cover
must be on the
outside of the shower.
Summary of Contents for Atlantis Glacier SFK-GL-HR
Page 1: ...SFK GL HR...
