REDSTONE 5906101924, Manual

Page: 24 / 56

24 | GB
12. Troubleshooting
Fault Possible cause Remedy
The compressor does
not start.
Mains voltage is not available. Check the cable, mains plug, fuse and socket.
Mains voltage is too low.
Make sure that the extension cable is not too long.
Use an extension cable with large enough wires.
Outside temperature is too low.
Never operate with an outside temperature of
below +5° C.
Motor is overheated.
Allow the motor to cool down. If necessary, remedy
the cause of the overheating.
The compressor
starts but there is no
pressure.
Safety valve (17) leaking.
Contact your local service centre. Only allow
qualified personnel to carry out repairs.
The seals are damaged.
Check the seals and have any damaged seals
replaced by a service centre.
Drain screw for condensate (10) leaking. Tighten the screw by hand. Check the seal on the
screw and replace if necessary.
The compressor
starts, pressure is
shown on the pressure
gauge, but the tools
do not start.
The hose connections have a leak.
Check the compressed air hose and tools and
replace if necessary.
A quick coupling has a leak.
Contact your local service centre. Only allow
qualified personnel to carry out repairs.
Insufficient pressure set on the pressure
regulator (5).
Increase the set pressure with the pressure
regulator.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised col-
lection point for the recycling of old electrical and
electronic devices. Improper handling of waste equip-
ment may have negative consequences for the envi-
ronment and human health due to potentially hazard-
ous substances that are often contained in electrical
and electronic equipment. By properly disposing of
this product, you are also contributing to the effective
use of natural resources. Information about collection
points for old devices can be found at your municipal
authority, the local disposal provider, an authorised
location for the disposal of old electrical and electron-
ic devices or your waste collection service.
10.9 Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*:Air filter
* may not be included in the scope of supply!
11. Disposal and recycling
The device is supplied in packaging to avoid
transport damages. This packaging is raw
material and can thus be used again or can
be reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plas -
tics. Take defective components to special
waste disposal sites. Check with your specialist deal-
er or municipal administration!