Effective from 29-Jul-21
Page | 3
MODEL: Nominal frame size
A (actual internal base size width) B (actual internal base size length)
C (actual internal diagonal – check)
2.36m x 1.5m
2300mm
1532mm
2764mm
2.36m x 3m
2300mm
3032mm
3806mm
2.36m x 4.5m
2300mm
4532mm
5082mm
2.36m x 6m
2300mm
6032mm
6456mm
2.36m x 7.5m
2300mm
7532mm
7875mm
2.36m x 9m
2300mm
9032mm
9320mm
2.36m x 10.5m
2300mm
10532mm
10780mm
2.36m x 12m
2300mm
12032mm
12250mm
2.36m x 15m
2300mm
15032mm
15207mm
2.36m x 18m
2300mm
18032mm
18178mm
2.36m x 21m
2300mm
21032mm
21157mm
2.36m x 24m
2300mm
24032mm
24142mm
Stage 1: Assemble the side base rails and stand up the door end and the louvre end walls.
* On longer tunnels – Join the various length of side base rail sections so that they are both of equal length. Use two 16mm self-
drilling screws on the inside face to connect each joint/sleeve.
* The groove in the side base rail will face to the outside.
* The groove in the base rail at the door end base rail faces to the inside, This is so that the sliding door has clearance from the end
wall cladding when the door slides open.
* The groove for the rear wall base rail faces to the outside.
* Stand the pre-assembled end walls vertical with the brackets facing to the inside. The endwall base rails finish flush with the ends
of the side rails. (See Pic BR1 page 4)
* Stand up the pre-made end frames and attach them to the side base rails using three screws. (See Pic BR2 and BR1 page 4).
Note, the door end base rail
has the Duralock cover
clipping groove facing to the
inside
The door slider guide is to the
outside
