ELECTRICAL SYSTEM
20 – English
Fig. 1
Fig. 2
Fig. 3
Fig. 4
C
A
B
E D
F
Ignition system
1. Remove the cylinder cover and starter assembly.
2. Release the blue lead (A) (which connects to the
stop switch) from the ignition module (B). See fi g. 1.
3. Remove the HT lead (C ) from the spark plug,
release both leads from the cable guide (D) and lift
out the cable guide. See fi g. 1.
4. Undo the two M4-bolts and remove the ignition
module (B). See fi g. 1.
5. Undo and remove the two pawls (E) for the recoil
starter. See fi g. 1.
6. Remove the spark plug and fi t the piston stop tool in
the spark plug hole. See fi g. 2.
7. Release the fl ywheel nut. Undo the nut until it is in
line with the thread on the shaft outer end. See fi g. 3.
8. Attach the fl ywheel puller. Tighten down the two M5
x 25- bolts approx. 10 turns. Tighten the central bolt,
while preventing rotation with the holding tool, until
the
fl ywheel comes loose. See fi g. 4.
9. Remove the puller, nut, washer and fl ywheel.
Dismantling
Cleaning and inspection
Clean all components, especially the tapers on the
fl ywheel and shaft.
Check that the fl ywheel is not cracked or damaged in
any other way.
