RDL-3000
FAMILY
USER MANUAL
70-00158-03-00
Proprietary Redline Communications © 2015
Page
200
of 254
April 17, 2015
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Where DFS is required by regional regulations, this function is permanently enabled
at the factory and can not be disabled by the installer or end-user.
4.
FCC Information to Users @ FCC 15.19:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that
may cause undesired operation.
5.
FCC Information to Users @ FCC 15.21:
Warning: Changes or modifications not expressly approved by Redline
Communications could void the user’s authority to operate the equipment.
FCC Recommendations to UNII band Users
Redline, in complete cooperation with the FCC, instructs professional installers and
operators of this equipment in the UNII band to follow these guidelines.
Review Table 3: Notice - FCC - TDWR System Locations to determine if the intended
deployment location is near a TDWR site.
1.
Operation in the TDWR band of 5600-5650 MHz is not permitted. The equipment
does not allow the operator to use Web, CLI, or SNMP to set a frequency that
overlaps this range.
2.
Operation in the 5570-5680 MHz band (excluding 5600-5650 MHz) is permitted
beyond 35 km (22 mi) AND not in line-of-sight of a TDWR site.
3.
Operation in the 5570-5680 MHz band (excluding 5600-5650 MHz) within 35 km (22
mi) OR in line-of-sight of a TDWR site is allowed by observing a 30 MHz upper and
lower guard band on the operational frequency of the nearby TWDR station.
For example, if the nearby TDWR is Miami (5605 MHz), the sector controller
frequency setting must exclude channels with center frequencies from 5575 MHz (30
MHz below 5605) to 5635 MHz (30 MHz above 5605).
It is recommended that the operator register in the voluntary WISPA sponsored
database. Go to the www.wispa.org website and click on TDWR to view more
information and register in the online database.
Frequency selection is regulated by a regional code integrated into each options key.
This feature enforces compliance to regional regulatory statutes. Each options key is
keyed to the unique MAC address of an RDL-3000 radio platform. Options keys can be
generated only by Redline and its authorized agents. End-users can not generate or
modify options keys (to obtain or alter regional codes).
Redline provides technical training programs and information covering network design
and installation for Redline distributors, value added resellers, installers, and other
