SET UP MOTION CONTROL (MOCO)
NOTE:
Motion Control requires a DSMC2 Base Expander. For more information, go to
NOTE:
When using MoCo, set the frame rate to be at least two times (2x) the fastest trigger rate used. When using
MoCo, REDCODE is calculated based on fps/2. Therefore, if you are in MoCo mode, and the frame rate is 100.83 fps,
the maximum REDCODE is calculated based on a frame rate of 50.415 fps.
NOTE:
HDRX is not available when MoCo is enabled.
NOTE:
Genlock and timecode can also be used with MoCo.
Motion Control, or “MoCo” for short, is a form of sensor synchronization used to automate precision camera
movements required for special effects and difficult shots. Motion Control uses GPIO signals transmitted using the
SYNC (GPI) and CTRL (GPO) ports on the DSMC2 Base Expander or DSMC2 V-Lock I/O Expander.
For more information on GPIO connections, go to
"Input/Output Connectors" on page 193
To set up MoCo, follow the instructions below:
1. Connect the Motion Control device to the camera using a 3BNC-to-00 LEMO Sync Cable.
Sync In
: Connect the white BNC connector to the Motion Control device and the 00B LEMO connector to the
SYNC
port on the expander.
Sync Out
: Connect the yellow BNC connector to the Motion Control device and the 00B LEMO connector to
the
CTRL
port on the expander.
2. Go to
Menu
>
Settings
>
Setup
>
GPIO/Sync
>
Sync
.
3. Select
MoCo
from the
Sensor Sync Mode
drop-down menu.
Figure: MoCo Sync Settings
4. Select the
BRAIN GPIO
tab.
C O PYR I G HT © 2 0 1 7 R ED.C O M , I NC
9 5 5 - 0 1 2 7 _V 6 .3 , R EV - M
|
1 6 6
RED RAVEN OPERATION GUIDE
