MASTER/SLAVE OPERATION
NOTE:
Master/Slave operation, including stereo/3D and camera arrays, requires a GIG-E port, which is available on the
DSMC2 REDVOLT Expander and DSMC2 Jetpack-SDI Expander. For more information, go to
NOTE:
The Master camera controls metadata and basic camera parameters of the Slave cameras. Any other setting
changes required by the Slave cameras must be made before recording.
This section describes operation in Master/Slave configuration and clip naming conventions for clips recorded on
those cameras. Master/Slave is the most common configuration for Stereo/3D productions.
When cameras are operated in Master/Slave configuration, you can perform the following operations:
Power
: Turn off the Master camera to turn off both cameras.
Record
: Press the
PWR/REC
key on the Master camera to start/stop recording on both cameras.
Change settings
: Change settings on the Master camera, to change settings on the Slave camera.
For a Master/Slave configuration to function, the cameras must have the same:
Firmware version
Project time base
Recording frame rate
BRAIN
Sensor
C O PYR I G HT © 2 0 1 7 R ED.C O M , I NC
9 5 5 - 0 1 2 7 _V 6 .3 , R EV - M
|
1 5 9
RED RAVEN OPERATION GUIDE
