Red Hat ENTERPRISE LINUX 3 - FOR IBM S-390 AND IBM ESERVER ZSERIES, Installation Manual

Page: 21 / 108

Each of the values used in the FCP parameters (FCP_1, FCP_2, ...) are
site-specific and are normally supplied by the FCP storage administrator.
The following parameter for kickstart installations is optional:
•
RUNKS=<value>
Where
<value>
is defined as
1
if you want to run the installation program in noninteractive
mode in the 3270 terminal, or
0
otherwise.
Note
Make sure that your kickstart file contains all required parameters before you use
this option.
If any of the network parameters required to make the network operate correctly are omitted
from the
parm
file, a prompt appears during the installation boot process.
If you logged off, reconnect and log in using z/VM guest ID you configured for installation. If you
are not in CMS mode, enter it now.
i cms
Create an executable script containing the commands necessary to IPL the kernel image and
start the installation. The following sample script is a typical initial start-up script:
/* */ 'CL RDR' 'PURGE RDR ALL' 'SPOOL PUNCH * RDR' 'PUNCH KERNEL IMG A
(NOH' 'PUNCH REDHAT PARM A (NOH' 'PUNCH INITRD IMG A (NOH' 'CH RDR ALL KEEP
NOHOLD' 'IPL 00C CLEAR'
The initial installation start-up script prompts you for information about your networking and
DASDs unless you have specified all necessary information in the
parm
file.
Once all questions have been answered, you are ready to begin the core installation program,
loader. To continue with the installation, refer to Chapter 2, Installing Red Hat Enterprise Linux
for further instructions.
6. Installing on a zSeries LPAR: Preparation
Installing on a zSeries LPAR: Preparation
11