5
www.RedDevilEquipment.com (PHONE) 800-221-1083 | (INTL) +1-763-533-2969 | (FAX) 763-852-1811
1785871 Rev J
ECO 15-0051 B
December 2015
Owner’s Manual: XVL10
1.2 Safety Precaution Summary
...Safety Information, continued
WARNING!
DO NOT
attempt to replace any damaged
electrical wire or components. Improper
replacement could result in electric shock and
serious injury. Only a qualified service
representative should attempt to repair or
replace any damaged electrical components.
Review this owner's manual before installing
or operating.
The machine must be properly grounded
prior to use. In the case of an electrical short
circuit, grounding reduces the risk of electric
shock by providing an escape wire for the
electric current.
The machine’s power cord has a grounding
wire with an appropriate grounding plug. This
plug must be inserted into an electrical outlet
that is properly installed and grounded
according to all local codes and ordinances.
If you must repair or replace the power cord
or plug, do not connect the grounding wire to
either flat-blade terminal. The wire with
insulation having an outer surface that is green
(with or without yellow stripes) is the grounding
wire.
Check with a qualified electrician if you don’t
completely understand these grounding
instructions, or if you are not sure whether the
machine is properly grounded.
Do not modify
the plug provided; if it won’t fit in the outlet,
have a proper outlet installed by a qualified
electrician.
Disconnect the power cord before servicing,
cleaning, or removing any covers
Follow the lockout/tagout procedures of your
company.
CAUTION!
Keep the work area free of clutter and
electrical cords.
Avoid extension cords. To minimize the risk
of improper electrical grounding, extension
cords are not recommended. If an extension
cord is unavoidable, consult a qualified
electrician to determine what type of extension
cord will satisfy the grounding, current capacity,
and other requirements of the particular
situation.
Use the proper power source. Refer to the
machine data plate on the right side panel or
the section 2.1,
Specifications
, in this manual.
Keep customers away from the work area.
The machine should be used only by properly
trained individuals.
DO NOT
open the door until the machine
comes to a complete stop.
To avoid electric shock, don’t get the timer,
control panel, or wiring wet.
This machine is not explosion proof.
All containers must be properly sealed and void
of leaks.
Review product label, Material Safety Data
Sheet, and HMIS rating of materials prior to
mixing to determine potential hazards.
DO NOT
use solvent-based cleaners or
thinners.
Use in a dry and well-ventilated environment
where dust and flammable vapors are not
present.
Product safety labels should be inspected
and cleaned periodically to maintain good
legibility. Replace any labels that are no
longer legible.