CAUTION!
Due to pressurization, water on and around the closure may be sucked in at time
of opening. Please be sure to wipe excess water from housing before opening.
CAUTION!
Before using, please be sure to test the housing (without camera) with Lens Port
properly attached in bucket or aquarium if available. After use in salt water, rinse thoroughly
in a bucket of fresh water without fail, pressing all buttons and turn all dials several times to
flush out salt deposits and other contaminants. Allowing saltwater and contaminants to dry on
housing can damage functions and O-rings. Clean with fresh water only, using a soft, dry
cloth to wipe away water.
INSTALLING CAMERA
※
Please perform proper Housing and Port O-RING MAINTENANCE prior to installation.
※
Please conduct the following operations in a clean area with low humidity and dust.
※
Camera can be inserted with lens port attached.
1. Check camera settings, battery is charged and media storage capacity is sufficient.
2. Using the lanyards provided, attach Camera Extraction Tabs to the camera’s strap
mounts as shown below.
3. Make sure the housing Mode Dial is pulled (or pushed) outward away from housing and
the Flash Up Lever is positions as shown below, and the the Zoom Lever Lock Screw is
NOT engaged (i.e. Zoom Lever is free). If this is not done, the camera may come in
contact with the housing dials and lever internal parts not allowing the camera to be
properly seated.
4. Slowly and carefully install camera making sure camera does not to hit housing's
internal controls while making sure the Camera Extraction Tabs do NOT become wedged
5.
