※
Please conduct the following operations in a clean area with low humidity and dust.
CAUTION!
Only use the Lens Ports intended for each this housing. Failure to use the proper
Lens Port could result in image vignetting and distortion, as well as possible water leakage
and/or damage to the camera.
1. Prepare the Lens Port to be used.
2. Lightly grease-up Lens Port's inner O-ring contact surface.
3. Place Lens Port over Housing Port Mount with Lens Port Lock Tab aligned with housing's
lower right Port Mount Lens Port groove, below the Port Lock Release Button.
4. Make sure the Lens Port is resting evenly on the Port Mount and then push down onto
Port Mount.
5. With Lens Port evenly pushed down onto Port Mount, rotate Lens Port counterclockwise
until the Port Lock Button engages with an audible click.
REMOVING LENS PORT
CAUTION!
After use in water, before removing Lens Port wipe any water off Housing and
Lens Port with a soft dry towel to prevent water from falling into the housing and onto
camera.
1. While pressing the Port Lock Button, rotate Lens Port clockwise until it stops.
2. Pull Lens Port outwards away from housing to remove.
INTERNAL AND EXTERNAL STROBE
The Accessory Shoe on top of the housing can be used for installation of a target light.
Please be mindful of the weight of the light(s) you intend to use. For heavy lights and strobes
please use optional Grip & Tray Assembly and compatible connector. Please refrain from
using lights attached to the Accessory Shoe as a carrying handle.
CAUTION! Damage is
irreparable.
※
While in the housing, the camera's on-board strobe can be deploy using the housing Flash
Up Lever. The CANON G1XMkII camera's on-board strobe does NOT close automatically
when camera is turned OFF. Be sure to manually close the strobe using the Flash Close
Dial before removing camera from housing.
※
Use the Strobe Mask-External Strobe Connection Mount and screw to connect external
strobe fiber optic cable.
Connecting fiber optic cable for external strobe use:
CAUTION!
Store Strobe Mask-External Strobe Connection Mount and Screw in a secure
place so as not to lose them.
7.
