Recsea CWOP-SH2, Manual

Page: 8 / 13

※
NOTE: Firmly press Lock Button while turning dial. Failing to do so may cause damage to
locking mechanisms.
INSTALLING CAMERA
CAUTION! Before using, please be sure to test the housing (without camera) in a bucket of
freshwater. After use in salt water, rinse thoroughly in a bucket of fresh water without fail,
pressing all buttons several times to flush out salt deposits and other contaminants. Allowing
saltwater and contaminants to dry on housing can damage functions and O-ring. Clean with
fresh water only, using a soft, dry cloth to wipe away water.
※
Please perform proper Housing and Port O-RING MAINTENANCE prior to installation.
※
Please conduct the following operations in a clean area with low humidity and dust.
1. Make sure the housing Mode Dial is pulled (or pushed) upward away from housing and
the Flash Switch Dial is bulled outward from the back cover. If these step is not taken, the
camera may not seat properly into housing and may cause buttons, dials and levers to
not function as intended.
2. Check camera settings, battery is charged and media storage capacity is sufficient.
Slowly and carefully install camera making sure camera does not hit housing's internal
controls. If the camera is not inserted correctly, buttons, dials, and levers may not work
properly.
3. Gently push camera forward into housing to make sure it is properly seated. If the camera
is not seated correctly, buttons, dials, and levers may not work properly.
4. After performing O-ring Maintenance, carefully close back cover making sure nothing is
caught between the Back Cover O-ring and housing body Contact Surface.
REMOVING CAMERA
CAUTION! After use in water, water will remain in seams between housing, back cover and
Lip-Hinge. Wipe any water off housing with a soft dry towel to prevent water from falling on
camera.
1. Pull Mode Dial upward away from Housing.
2. Open and remove Back Cover as instructed in OPENING AND CLOSING THE BACK
COVER.
3. Tip Housing backwards, gently sliding camera out of housing.
HANDLING PRECAUTIONS
The Lens Port lens is manufactured using hard coat acrylic. When cleaning use a clean soft
cloth taking care not to scratch it.
INTERNAL AND EXTERNAL STROBE
※
For heavy strobes and lights please use optional Grip & Tray Assembly and compatible
connector.
※
While in the housing, the camera's on-board strobe can be deploy using the housing Flash
Switch Dial. The OLYMPUS Stylus SH-2 and SH-1 cameras' on-board strobe do NOT
close when the camera is turned OFF. Be sure to manually close the strobe once removed
from housing.
※
Use the Strobe Mask-External Strobe Connection Mount to connect external strobe fiber
optic cable or plug.
6.