15
Mounting the Profiled Leather
Honing Wheel
The
WG250/N
Profiled Leather Honing Wheel is an
optional accessory.
1. Install the
WG250/N
Profiled Leather Honing Wheel on
the shaft next to the leather honing wheel (A).
2. Place a washer on the shaft and tighten the lock knob (N).
N
A
O
Mount the Water Tank
1. Install the water tank (F) on the side of the machine.
2. Fill the water tank with water up to the “MAX” marked
water level.
Note:
The stone will soak up a lot of water (approximately
0.5 litre) in the first 15 minutes. When the stone
wears down to a smaller diameter the second (upper)
mounting position for the water tank has to
be chosen.
Mount the support arm
1. Install the support arm (G) to the machine.
2. Depending on the sharpening job the support arm can be
installed in a vertical or horizontal position allowing you
to grind towards or away from the edge.
F
G
8. Assembly - Cont.
Summary of Contents for WG250
Page 37: ...37 14 Parts Lists Diagrams ...
