17
Thicknessing
1. Adjust the thicknessing table height to suit the workpiece.
2. Activate the feed by raising the feed clutch lever (A -
Fig 5.15
) then
release it.
3. Slide the work-piece into the machine until it is drawn in by the
feed rollers.
4. If trouble occurs during thicknessing (e.g. protruding knot/nail or the
work-piece become extremely tapered) switch off the feed immediately and
lower the thicknessing table to free the workpiece.
A maximum of 2 work pieces can be fed through the thicknesser
simultaneously. These must be pushed in at each end of the feed roller,
Fig 5.16
.
Warning: If the workpiece becomes trapped when feeding
into the thicknesser, immediatelly switch the machine off and
disconnect from the power before attempting to free the
work piece.
Fig. 5.15
Fig. 5.16
A
5. Operation
i
Kg
i
Kg
Summary of Contents for PT107
Page 29: ...29 10 Parts List Diagrams cont ...
Page 33: ...33 ...