ReChargX
™
RX292
8am - 8pm ET Mon - Fri
© 1995-2014 ReChargX, EmptyX, TonerRefillKits, TonerRefillKits.com, the TonerRefillKits logo, the
V1.01 - 2014.06.24
800.527.3712 or 352.343.7533
ReChargX and EmptyX logos are trademarks owned by TonerRefillkits.com, LLC. All rights reserved.
Page 4 of 12
Step 7: Create the toner hopper fill hole
After waiting for all of the sand to run through the
sand timer (the full 3 minutes) place the ReChargX™
hole-making tool directly over the location for the
hopper hole and firmly press the copper hole-making
bit against the cartridge (figure 7-1).
There is no need to use excessive force; let the
hole-making tool do the work with a minimal amount
of pressure.
Since these toner cartridges have a relatively thick
housing, a slight rocking motion of the tool will help
the hole-making bit penetrate the surface of the toner
cartridge.
Once the copper tip of the hole-making tool
penetrates the top surface of the toner cartridge,
immediately withdraw the tool and unplug it.
Step 8: Remove the plastic disc from the
hole-making tool
While the bit on the hole-making tool is still hot, use
the tip of the flat-blade screwdriver (included in the
ReChargX™ tool kit) to remove the small, circular
plastic disc (figure 8-1).
At this time you can also remove any plastic on the
exterior of the bit with the green pad (included in the
ReChargX™ tool kit).
Note
: If the tool has cooled down before extracting
the plastic disc, the disc may become hardened and
stuck in the tool. If this happens, plug in the tool, wait
at least 3 minutes (using the sand timer) for the tool
to heat up to soften the plastic disc, then remove as
shown in figure 8-1.
Step 9: Add ReChargX™ RX292 premium print
toner to the toner hopper
Before starting the toner hopper refilling process
(and after verifying the bottle cap is screwed firmly in
place), gently rock or shake the bottle back-and-forth
several times to ensure the toner will flow smoothly
(the toner can settle and compact during shipping).
Remove the original cap from the toner bottle and
attach the clear, plastic dispenser spout from the
ReChargX™ RX292 premium print toner refill kit.
Figure 7-1:
Creating the toner hopper fill hole
Figure 8-1:
Removing the plastic disc from the hole-making tool
