25
24
9. If the ProRIDE is too
upright, loosen both mini-
connector tethers and place
a tightly rolled towel or foam
pool noodle under the base
below where the child’s feet
will be located.
NOTE:
Do
NOT
place anything
under the ProRIDE base,
except as shown in Fig. 9.
10. Follow steps 1-8 to secure the ProRIDE after adjusting the
angle.
11. After adjusting the recline angle, check that the ProRIDE is
tight and properly secured. The ProRIDE should not move
more than
1 inch (2.5 cm)
in any direction at the belt path.
12. To remove the mini-connectors from the vehicle, first
loosen both adjusters by pressing the adjuster button and
lengthening the straps (see Fig. 3). Press the red buttons
on the mini-connectors and remove from vehicle lower
anchors (see Fig. 6).
13. Replace the mini-connectors into the storage slots at rear
of base.
9
REAR-F
ACING
- Latch Installation
Summary of Contents for ProRIDE
Page 2: ...B ...
