Real Flame Element 1200 MARK 2, Installation And Operation Manual

Page: 65 / 126

65
Page
Fan module outlet
connection
Cut tube to length where
required. Ensure ends
are burr free and round,
test fit flue will slide over
connection.
Slide flue onto connection
spigot fully.
Tighten clamp fully.
Wipe excess silicon,
visually check connection
to ensure connection is
fully sealed.
Apply an 8mm thick silicon
bead fully around heater
connection approx. 10mm
from the top.
Apply an 8mm silicon
bead fully around the
inside of the flue end
(heater connection end)
Fit flue clamp over flue
(loosely).
Repeat for air intake flue
connection.
Repeat for connection to underside of fan module.
6. Connect power
lead to fan module.
Ensure lead is clipped
to support where
required.
Do not use connection to
support lead.
Slide flue onto connection
spigot fully.
Tighten clamp fully.
Wipe excess silicon,
visually check connection
to ensure connection is
fully sealed