Page 22
After Autoset
Real Carriage Door & Sliding Hardware Copyright 2020© all rights reserved
of electricity
• If you are getting power to the control unit but
the nothing will work (and there may also be
a buzzing noise from the transformer) check
the fuse located next to the transformer. It is
located in a black rubber junction in the wiring
• If you are getting intermittent operation with the
opener check to make sure nothing is between
the rail and chain. For example if a scew or
other object touches it will cause a short
2. Door autoset process does not stop
• If the motor continuously goes back and forth
in autoset process your door is most likely
traveling less than 4ft. The motor requires a
minimum 4ft of travel to properly complete the
autoset process
•
Hold the resett button to full factory reset (30
seconds). Turn dip 3 OFF and turn dip 4 ON.
This will correct the issue but motor will run at
slower speed. Redo autoset process
Note:
For installation videos look up Roman Troyer’s
youtube channel and Sommer USA.
After Autoset
Completion
Battery Pack (ACCU) Installation
The battery pack is optional except for California
residents.
If the battery back has not been installed yet follow
instructions on page 18, and if it is installed then
complete below steps. Requires 24 hours of charge.
Run a function test (after 12hr of charging):
3. Pull the power plug out of the power outlet
• The opener is now powered by the battery pack
4.
Press the button on the transmitter
5. Opener opens or closes the door at reduced
speed
6.
Plug the unit back into the power plug
Adjusting the Close Limit
If after the autoset you determine you need more
closing pressure on the doors then follow below
instructions.
1.
Press and hold the reset button for 10 seconds
• This will delete limit settings without resetting
entire opener
2. Begin autoset process again starting on page
21
•
Add in an extra “hop” iwhile programming the
close limit
