Installation
Real Carriage Door & Sliding Hardware Copyright 2020© all rights reserved
Installation
Instructions
•
Wood drill 3/16”
•
Concrete drill 1/4”
•
Wrench 1/2” and 3/8”
•
Ratchet driver 1/2” and 3/8”
Connecting the rails
1. Take your rails and parts boxes out and set
aside
2.
Slide the bridges (part 3) onto each end of Part
2 (track with motor carriage)
3.
Proceed to slide other rails (part 4) into the
bridges until they meet
with the edges of
Part 2
4.
Stretch the chain across the length of the track
Chain Tensioner
Note:
The chain tensioner goes on closing end,
while as the wire connector is for the open end.
1. Slide chain tensioner (part 5) into the opening
end of the track
2. Stretch the chain
3.
Rotate it 90 degrees so it slides into the chain
holder
4.
Make sure the tensioner is loosened before
attaching chain
5. Rotate the chain back so it locks into place
Wire Connector
1. Slide wire connector into end of rail behind red
limit stop (open end)
2. Pull chain across the rail and lay chain over the
red limit stop until it reaches the wire connector
3.
Rotate the chain 90 degrees and insert into
Page 14