re3D Gigabot X, Getting Started Manual, Page: 3 / 30

Safety Instructions
3
READ INSTRUCTIONS
All the safety and operating instructions must be read before the printer is operated.
RETAIN INSTRUCTIONS
The safety and operating instructions should be retained for future reference or accessed
on our Knowledge Base here:
https://bit.ly/gigabotguides
HEED WARNINGS
All warnings on the product and in the operating instructions should be adhered to.
FOLLOW INSTRUCTIONS
All operating and use instructions should be followed.
CLEANING
Unplug this product from the wall outlet before cleaning. Compressed air and vacuums can
be used for dust or particle removal. Only water and isopropyl alcohol may be used to
damp a lint-free rag to wipe off dust and bed surface adhesives.
ATTACHMENTS
Do not use any attachments or enhancements not recommended by the product
manufacturer as they may cause hazards.
WATER AND MOISTURE
Do not use Gigabot® X near water such as a sink or other water source. The relative
humidity of the environment should ideally be between 0%-50%. Feedstock should be
stored in dry boxes if the environment is too humid or if the material is moisture-sensitive.
PLACEMENT
Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product
may fall, causing serious injury to a child or adult, and serious damage to the product. Place
the product only on stable surfaces recommended by the manufacturer, or sold with the
product.
VENTILATION
Slots and openings in the enclosure are provided for ventilation to ensure reliable
operation of the product. To protect it from overheating, these openings must not be
blocked or covered. This product should not be placed in a built-in installation such as a
bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions
have been adhered to.