re3D Gigabot X, Getting Started Manual, Page: 14 / 30

IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
If all the quadrants have a value other than
zero, then the Z height must be adjusted
(otherwise, skip to B10). To do this, move the
tool setter to the back left quadrant. Use an
8mm combination wrench to adjust the
[10245] M5 x 70 HHCS on the upper Z limit
switch leveling block (on the right side of the
machine). Turning counterclockwise when
viewed from above will increase the Z height,
and clockwise will decrease the Z height.
14
B7
Repeat steps B1 to B5 until the tool setter
reads zero. The Z height is now set correctly in
relation to the back left quadrant of the bed.
B8
Recheck the Z height at each quadrant. If the
tool setter reads zero at all quadrants, then
the bed is level and you can skip to Section A.
If the tools setter does not read zero at any
quadrant, the bed is not level.
B9