BURNERS CLEANING & MAINT
E
NANCE
Burners are made of heavy gauge
stainless steel
and can be cleaned using a bristle brush,
warm water and soap. Check every port hole for clogs. Use a wire pin to clean out clogged
ports. Make sure the burner is dry before installing it back to the Pr
o
Burner.
DRIP
PAN
The drip pan collects grease, liquid and fallen food particles. Allow the pan and its contents to
cool before cleaning. Slide the pan out and wipe it clean. Make sure the drip pan is fully inserted
back into the Pr
o
Burner. It is highly recommended to clean the pan after every use
to avoid any possibility of a grease fire. DO NOT use the Pr
o
Burner without the drip pan
pushed all the way to the back of the Pr
o
Burner unit.
OPERATING
INSTRUCTIONS
BEFORE
LIGHTING
THE
PR
O
BURNER
1)
DO
NOT
ATTEMPT
TO
LIGHT
THE
PR
O
BURNER
IF
YOU
SMELL
GAS.
2)
WARNING
!
IT
IS
CRITICAL
THAT
THE
GAS
BURNERS
ARE
PROPERLY
INSTALLED
WITH THEIR
ORIFICES
INSIDE
THE
BURNERS
AIR
SHUTTERS.
If
not
properly
installed,
gas
may
leak
outside
of
the
burner
that
could
lead
to
fire,
potential
damage
to
your
Pr
o
Burner
and
bodily
injury.
Inspect the gas supply piping or hose prior to turning the gas ON. If there is evidence of cuts,
wear, or abrasion, it must be replaced prior to use. The replacement pressure regulator and
hose assembly must be the type specified by the manufacturer. Do not use the Pr
o
Burner if
the odor of gas is present.
If the unit is LP, screw the regulator and hand tighten to the valve of the cylinder and leak
check the hose and regulator connections with a soap and water solution before operating the
Pr
o
Burner. Make sure you always read about LEAK PRVENTION.
Always keep your face and body as far away as possible when lighting.
Refer to spiders and insects warning and procedure under the cleaning and maintenance page
of this manual.
