12
11
For further instructions on DMX wiring and
installation, please refer to DOC-083.
DMX cable runs must be terminated using a 1W 120
Ω resistor that is connected to the last 3-way
connector in the spotlight chain.
NOTES
If DMX or DALI control is specified, run appropriate
cable to the mounting hole and connect to the
monopoint head using the 3-way connector supplied
Insert the control gear through the mounting ring
onto the upper surface of the ceiling.
PAGE 7
13
14
15
16
Insert DR8 Monopoint head into mounting ring.
Twist spotlight clockwise and pull down gently to lock
in place.
For multiple fixtures, Align primary hooks (denoted by
a directional arrow) perpendicular to a feature such as
a wall or trough edge to ensure all fixtures will align.
Ensure that the monopoint head studs locate securely
in the mounting ring hooks, as shown below.
9
10
8
7
4
5
6
Insert the mounting ring into the hole so that it sits
flush with the ceiling.
Holding the mounting ring in place, insert a fixing clip
into a slot on the mounting ring.
Slide the fixing clip down the slot until it hits the
ceiling material.
Ensure that the luminaire is securely installed, with the
fixing clips firmly against the ceiling material.
Insert fixing studs into mounting ring holes and, using
a 2.5mm hex screwdriver, secure the clip in place.
Repeat this process for each fixing clip.
Run mains voltage cable to the hole and connect to
the luminaire using an electrical connector (not
supplied).
If for any reason the mounting ring cannot be fitted
securely, stop the installation and contact RCL.
WARNING
For projects that require DMX or DALI control, a
3-way connector will be present on the monopoint
head.
PAGE 6
