EN
21
Advanced Sound Control
Fine Setting of the Speakers
All the basic settings have already been pre-set for the
speakers included in the box.
Also, to make the surround sound more effective and
suit the acoustic conditions in your listening room, you
may need to delay the signal coming from some of the
speakers. Channel delay compensates for center or
surround speakers that are closer to the listening
position than the front speakers. You can make use of
the
SETUP
button to adjust the speakers’ relative
loudness.
Testing Speaker Loudness
You can listen to the loudness of the individual speakers
by doing the following:
1. Press and hold
LEVEL
on
the remote control.
A short noise will be
heard in the speakers one
by one. The speaker
having the noise at that
moment will be shown in
the display.
2. To adjust the volume level of the test tone, turn the
VOLUME
knob or press the
VOL Up
or
DOWN
buttons on the remote control to adjust the master
volume (if necessary).
Press
LEVEL
again and
press the Up or Down
buttons to adjust the
individual channel noise
level.
Adjust Individual Speaker Volume
1. To adjust individual speaker volume level, press the
LEVEL
key on the remote control.
2. Continue to press the
LEVEL
button on the remote
control to select the channel to be adjusted, then
press the Up or Down buttons to adjust
the level.
You can adjust the master volume level by turning the
VOLUME
knob or press the
VOL UP
or
DOWN
buttons
on the remote control.
Advanced Setting
Factory defaulted Advance setting
indication from VFD
The receiver has defaulted the following distances:
Front speakers (FRNT)
15 ft
Center speaker (CNTR) 15 ft
Rear speaker (SURR)
10 ft
R/S
L/S
Rch
Cch
Lch
Front
Left
Rear
Right
Rear
Left
Front
Right
Center
VOLUME
PRESET
RT2620 EN 4/7/04 1:42 PM Page 25