Getting Started
EN
9
Test Tone / Channel balance
Channel balance
Your receiver is equipped with a test signal generator
for balancing the channels. As the signal "travels" from
channel to channel, adjust the level controls until each
channel plays at the same loudness level.
To activate and adjust test tone, refer to “Testing
Speaker Loudness” under the “Advanced Sound
Control” section (Pg 21).
Level adjustment & surround channel
level expectation
Even though you adjust the surround channel to be as
loud as the others on the test signal, you'll find that on
actual program material the surround channel is usually
much lower than the front. Don't be tempted to
readjust the surround level; program producers use
surround mostly for subtle atmospheric and ambience,
and only rarely for special effects. A good surround mix
doesn't call attention to itself; if it did, it would soon
become distracting.
Factory Setting
The unit is preset to the following settings when you
first power the receiver up right out of the box:
Function = TUNER
Volume setting = 25
Bass & treble = 0 dB
EQ = FLAT
Speaker settings: Center, surr = YES
Subwoofer = STRONG
DRC = OFF
Reset to Factory Settings
You may restore factory setting with the following
procedures:
1. Enter SAT mode.
2. Press
PRESET UP
,
PRESET DOWN
,
SOURCE
to
reset the unit.
All preset stations will reset to FM87.5MHz and all
receiver settings restore to default settings as described
above.
NOTE
The system is equipped with Dolby Digital,
and manufactured under License from Dolby
Laboratories.
Courtesy Dolby Laboratories
NOTE
STRONG SUBWOOFER setting makes the
output level of subwoofer speaker to be
stronger than normal Dolby setting. Adjust
the SUBWOOFER setting by pressing the
SUBWOOFER key to achieve the best bass
performance.
WARNING
All preset radio stations and surround
sound settings will be lost after factory
setting is restored.
Manufactured under license from
Digital Theater Systems, Inc. US Pat. No.
5,451,942, 5,956,674, 5,974,380,
5,978,762 and other world-wide patents
issued and pending. "DTS" and "DTS Digital Surround"
are registered trademarks of Digital Theater Systems,
Inc. Copyright 1996, 2000 Digital Theater Systems, Inc.
All Rights Reserved.
Manufactured under license from
Dolby Laboratories. “Dolby”, “Pro
Logic” and the double-D symbol are
trademarks of Dolby Laboratories.
Confidential Unpublished Works. © 1992-1997 Dolby
Laboratories, Inc. All rights reserved.
RT2620 EN 4/7/04 1:41 PM Page 13
