Setup and Connections
4
Step 1: Unpack the System
Make sure to locate the remote control.
Step 2: Connect Your Receiver to
Your TV and VCR
During the satellite dish antenna installation, the receiver may have
been connected to your TV with just a coaxial cable for the system test.
Depending on what components you have, another connection may
provide better picture and audio quality. The following sections provide
cable and connection information to help you decide what connection is
best for you.
Things to Know Before Connecting
Components
Protect Your Components from Power Surges
•
Connect all components before plugging any power cords into the
wall outlet.
•
Always turn off the receiver, TV and other components before you
connect or disconnect any cables.
Position Cables Correctly to Avoid Audio Hum or
Interference
•
Insert all cable plugs firmly into their jacks.
•
Place the audio/video cables to the sides of the TV’s back panel
instead of straight down the middle after you connect your
components.
•
Try not to coil any twin-lead cables and keep them away from the
audio/video cables as much as possible.
•
Make sure all antennas and cables are properly grounded. Refer to
the Safety sheet packed with your unit.
