7
Digital Connection
N
N
N
No
oo
otttteeeessss::::
• If the external equipment is a television and this audio system is
close to it, you may experience interference if the TUNER
function is selected while the television is working.
• When you have selected TUNER function, sound only comes
from the front left, right, and subwoofer speakers.
• While the VCR is connected to the DVD unit, make sure to set
your VCR to stereo mode, otherwise the activated speakers may
be different than expected. See “To Select the Listening Channel”
on Page 12.
• Due to copyright protection, DVD movies cannot be copied. If
you copy a DVD movie onto a videotape, the resulting copy will
be unclear, with poor sound quality. This is not caused by a
defective DVD system.
• When using the VCR, press
FUNCTION
on the remote control
or front panel until
AV IN
appears.
CONNECTING ANTENNAS
When connecting equipment, make sure the power is switched off
and the power cord is disconnected from the wall outlet.
FM Antenna
Press on the
FM ANT. 300
terminals and insert the supplied FM
antenna wire ends.
AM Loop Antenna
1. Plug the supplied loop antenna’s terminal into
AM LOOP ANT
.
The terminal fits only one way. Do not force it.
2. Snap the supplied stand to the bottom of the AM loop antenna
and place it on a flat surface.
3. Keep the antenna as far away as possible from the system,
speaker cords, and power cord to prevent unwanted noise.
CONNECTING THE SPEAKERS &
SUBWOOFER
The speaker cords have been color-coded to simplify connection.
Plug the POSITIVE (+) and NEGATIVE (-) ends of each speaker wire
into the corresponding jacks on the rear of the unit, matching the
color tube on the end of the speaker wire to the color-coded
connector.
Connect each of the speaker wires to the front, rear, and center
speakers respectively.
Positioning the Speakers
Mounting Rear Surround Speakers
1. Mark the correct mounting
position on the wall.
2. Insert a fixing screw at the
marked position on the wall.
3. Align the slot hole(s) of the
speaker over the screw and pull
the speaker downward until it is
firmly hooked.
Power Cord Connection
• Make sure that all the components and speakers are connected
correctly.
