8
Battery Care and Disposal
Do not store in freezing or below freezing temperatures. To properly maintain your battery and ensure maximum battery
life, carefully read the “Charging the Battery” section on page 4 of this owner’s manual.
Pb
Pb
CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED.
Disposal:
Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an
environmentally safe manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not
dispose of a lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed lead-acid
batteries with household trash is prohibited by law in most areas. Return exhausted batteries to a federal or state
approved lead-acid battery recycler or a local seller of automotive batteries. If you live in Florida or Minnesota, it is
prohibited by law to throw away lead-acid batteries in the municipal waste stream.
Charger
The charger supplied with the Ground Force Drifter should be regularly examined for damage to the cord, plug,
enclosure and other parts, and in the event of such damage, the product must not be charged until it has been repaired
or replaced.
Use ONLY with the recommended charger.
Wheels
Wheels and drive system are subject to normal wear and tear. It is the responsibility of the user to periodically inspect
wheels for excess wear and adjust and replace drive train components as required.
Replacement Parts
The most frequently requested replacement parts are available for purchase at some Razor retail partners. For the
complete selection of replacement parts visit shop.razor.com.
Repair Centers
For a list of authorized Razor repair centers:
• Check online at www.razor.com.
• Additional Customer Service contact information is listed on the back of this manual.
WARNING:
If a battery
leak develops, avoid contact
with leaking acid and place the
damaged battery in a plastic bag.
Refer to the disposal instructions
at left. If acid comes into contact
with skin or eyes, flush with cool
water for at least 15 minutes
and contact a physician.
WARNING:
Battery posts,
terminals and related accessories
contain lead and lead compounds.
Wash your hands after handling.
Self Adjusting Chain Tensioner
Motor shaft sprocket
Roller chain
Fixing bolt
Drive shaft sprocket
Note:
Proper alignment of the
chain must be maintained. If the
chain is adjusted properly, but
is noisy or rough running, check
alignment of the sprockets. The
drive-shaft sprocket can be adjusted
slightly from side-to-side by
loosening the set screw. Note that a
key way maintains the drive position
to the shaft.
Note:
Chain should be periodically
checked for grime build-up. If
necessary remove any dirt and/or
debris in and around the chain and
re-lubricate with WD-40
®
.
Master Link:
Replacing the Chain
Drive Direction
Master Link
Secure Clip
Link Plate
Connector Link
1
Locate the master link on the
replacement chain and with a
flat head screwdriver carefully
disengage the clip from the chain
to remove the link plate and
connector link.
2
Wrap the chain around both
sprockets and tension idler. Insert
the connector link all the way
through the chain and fit the link
plate over the connector link.
3
Using a flat head screwdriver,
carefully re-attach the clip on to
the link plate. The clip must point in
the drive direction of chain rotation.
REPAIR AND MAINTENANCE
