Need Help?
Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at
www.razor.com
. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
3
ASSEMBLY AND SET-UP
WARNING:
Failure to properly install and
tighten the screws, nuts and bolts
that affix the steering wheel and
seat can cause you to lose control
and crash.
WARNING:
The lap/shoulder belt arrangement
supplied with the Ground Force
Drifter is for “play” use only. It
is not an ASTM-approved safety
belt system and is not intended
to function as an approved lap/
shoulder/seat restraining device.
TURN POWER SWITCH OFF BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
Attaching the Steering Wheel
Tool Required:
5 mm Allen Wrench
4
Using a 5 mm Allen wrench,
alternately tighten each of the bolts
on the steering wheel clamp. When
the bolts are properly tightened,
the gap between the clamp halves
should be even.
1
Using a 5 mm Allen wrench,
loosen the screw located in the
steering column.
2
Make sure the wires are not
tangled. Insert the steering wheel,
washer and screw into the steering
column as shown.
3
Tighten screw
securely
using a
5 mm Allen wrench.
1
Position the seat over the frame
and align it with the holes in the
frame. Insert the four (4) seat bolts
and tighten securely.
Attaching the Seat
Tool required:
5 mm Allen Wrench
B
B
A
A
A
B
