Front Fork
Rear Brake Lever
Remove contents from box. Remove the foam separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have
occurred during shipping. Because the Dirt Rocket is 95 percent assembled and packed at the factory, there
should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY
MAINTENANCE PROCEDURES.
estimated assembly and set-up Time
Razor recommends assembly by an adult.
Allow up to 30 minutes for assembly.
Allow up to 12 hours for initial charge (see page 4 for charging information).
BefOre yOu BegIn
warnIng:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
DIRT ROCKET. The Dirt Rocket
has been built to certain Razor
design specifications. The
original equipment supplied at
the time of sale was selected
on the basis of its compatibility
with the frame, fork and all
other parts. Certain aftermarket
products may or may not be
compatible and may void your
warranty.
required Tools
5mm and 6mm Allen
wrenches
(Included)
3mm Allen wrench
(Not Included)
Spoke tightener
(Included)
Screwdriver
(included)
Bicycle tire pump for
Schrader valves, with
pressure gauge
(Not Included)
Speed Control
Drive
Chain
10mm open wrench
(Included)
8mm and 15mm open
wrenches
(Not Included)
Charger
(Note: Charger design may vary
from one shown)
