q
charging the Battery
Your electric motorbike may not have a fully charged battery; you must charge the battery prior to use.
warnIng:
Rechargeable batteries are
only to be charged under adult
supervision. Always disconnect
your electric motorbike from the
charger before cleaning with
liquid.
Note:
If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED to indicate the
charge status. Refer to the
illustration on the charger unit
for the actual “charging” and
“charged” status indications for
your model charger.
Chargers have built-in over-
charge protection to prevent
battery from being over-
charged.
Charger will get warm during
use. This is normal for some
chargers and is no cause for
concern. If your charger does
not get warm during use, it does
not mean that it is not working
properly.
asseMBly anD seT-up
BefOre rIDIng
q
Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of
manufacturing and your purchase.
Note:
The pressurized air
supplies found at gasoline
stations are designed to inflate
high-volume automobile tires.
If you decide to use such an
air supply to inflate your tires,
first make sure the pressure
gauge is working, then use very
short bursts to inflate to the
correct PSI. If you inadvertently
over-inflate the tire, release the
excess pressure immediately.
Using a bicycle tire pump equipped for a Schrader valve, inflate both tires to the PSI indicated on the
sidewall of the tire.
2
Turn power
OFF
before
charging. Plug the charger into
the charger port to charge unit.
1
Plug the charger into a wall
outlet. If the lights on charger
do not light up, check the power
to the outlet. If necessary, try a
different outlet.
Charger
warnIng:
Failure
to recharge the battery at least
once a month may result in a
battery that will no longer hold
a charge.
Note:
Make sure power is
turned
OFF
when unit is not in
use. If the power switch is left
on for an extended period of
time, the battery may reach a
stage at which it will no longer
hold a charge.
• Initial charge time: 12 hours
• Recharge time: up to 12 hours,
depending on level of depletion.
• Fully charge battery before storing.
• When the motorbike is not in regular use,
recharge the battery at least once a
month until normal use is resumed.
• Run time: Up to 30 minutes of continuous ride time.
Run time may vary depending on riding conditions,
climate and/or proper maintenance.
• Average battery life: 250 charge/discharge cycles
• To ensure long battery life, do not store the battery
in temperatures above 75° or below -10° F.
