Raytheon HSB L755, Owner'S Handbook Manual

Page: 51 / 224

Chapter 2: Installation 2-21
In
st
alla
ti
o
n
Figure 2-15: Cutting the Fairing
CAUTION:
The arrow on the fairing always points forward towards the bow. Be sure
to orient the fairing on the band saw so the angle cut matches the intended
side of the hull.
3. Place the fairing on the table so the cutting guide rests against the fence.
The arrow/blunt end will point toward you for installation on the port side
and away from you for installation on the starboard side of the boat. The
fairing must be between ¼ – ½ " (6–12 mm) at the thinnest spot (see
Figure 2-12).
WARNING:
Always wear safety goggles and a dust mask when drilling.
4. Recheck steps 1 through 3, then cut the fairing.
5. Shape the fairing to the hull as precisely as possible with a rasp or power
tool.
Seating
CAUTION:
Never pull, carry, or hold the transducer by the cable because doing so
can sever internal connections.
1. Remove one safety ring, retaining pin, cap nut, and hull nut from the trans-
ducer. Grasp the paddle wheel insert by the pull ring and pull slowly
upwards (see Figure 2-16).
Cutting guide
Fence
Band saw table
Bow end for
installation
on port side
Deadrise
angle
4860_1